Retainer Clip Release Tool #STC21715 Automotive dent repair

Retainer Clip Release Tool #STC21715 Automotive dent repairTraditionally, accessing the expansion ears can be time consuming, often requiring the removal of additional parts to gain proper access. Technicians, in a hurry, might resort to pulling off the molding without releasing the clip properly, resulting in broken clips and wasted time. The Steck Retainer Clip Release Tool eliminates these challenges by allowing you to release retainer clips from the outside. By sliding the tool between the molding and the

Full-swivel chuck

compared to the usual $200-500 cost and 30-45 minutes of manual labor

000 Blows Per Minute (BPM) Bi-Directional Air Hammer / Air Puller Tool

Utilize the included thread gauge by setting it up tight against the vehicle wheel mounting stud or bolt to determine the correct size

Wheel vibration/pulsation

With the STC21960 SPR Insertion Tool

this inflator gauge provides precise and accurate readings for optimal tire inflation

5mm) LT1260 1/2″ Drive Dual Sided Socket Lugnut Removal Tool (22 – 22

offering unparalleled performance and convenience

The technician can replace the bearing assembly for around $45-70 in just about 5 minutes

Squeeze the trigger to allow air flow

made from high-quality vinyl